Grundfos TPE3 - Description of selected functions

English (US)
22
Settings TPE3 (D) TPE2 (D) Section Page
Setpoint ●●15.1 Setpoint 26
Operating mode ●●15.2 Operating mode 26
Set manual speed ●●15.3 Set manual speed 26
Control mode ●●15.4 Control mode 26
FLOW
LIMIT
●●15.5 FLOWLIMIT 31
Automatic Night Setback ● - 15.6 Automatic Night Setback 31
Analog inputs ●●15.7 Analog inputs 31
Analog input 1, setup ●●
Analog input 2, setup ●●
Analog input 3, setup ●
1)
●
1)
Built-in Grundfos sensor ● -
Pt100/1000 inputs ●
1)
●
1)
15.8 Pt100/1000 inputs 31
Pt100/1000, setup ●
1)
●
1)
Digital inputs ●●15.9 Digital inputs 32
Digital input 1, setup ●●
Digital input 2, setup ●
1)
●
1)
Digital inputs/outputs ●●15.10 Digital inputs/outputs 32
Digital input/output 3, setup ●●
Digital input/output 4, setup ●
1)
●
1)
Relay outputs ●●15.11 Relay outputs 33
Relay output 1 ●●
Relay output 2 ●●
Analog output ●
1)
●
1)
15.12 Analog output 33
Output signal ●
1)
●
1)
Function of analog output ●
1)
●
1)
Controller settings ●●15.13 Controller settings 33
Operating range ●●15.14 Operating range 34
Setpoint influence ●●15.15 Setpoint influence 35
External setpoint function ●●15.15.1 External setpoint influence 35
Predefined setpoints ●
1)
●
1)
Temperature influence ● - 15.15.3 Temperature influence 37
Monitoring functions ●●15.16 Monitoring functions 38
Motor bearing monitoring ●●
Motor bearing maintenance ●●
Limit-exceeded function - ● 15.16.1 Limit-exceeded function 38
Special functions ●●15.17 Special functions 38
Pulse flow meter setup - ● 15.17.1 Pulse flow meter setup 38
Ramps - ● 15.17.2 Ramps 38
Standstill heating ●●
Communication ●●15.18 Communication 38
Pump number ●●15.18.1 Pump number 38
Enable/disable radio communication ●●15.18.2 Enable/disable radio communication 38
General settings ●●15.19 General settings 39
1)
Only available if an advanced functional module is fitted.
Assist TPE3 (D) TPE2 (D) Section Page
Assisted pump setup ●●
Setup, analog input ●●
Setting of date and time --
Multi-pump setup ●●16.1 Multi-pump setup 39
Description of control mode ●●
Assisted fault advice ●●