35
Viewing Audit Trail Parameters
Audit trail parameters may be viewed at any time.
To view audit trail parameters:
1. Press EJBJ@ !.
DISPLAY READS X Audit ~ Trail~CAL. ~ 00001
2. Press
! again to view the Setup Audit Trail parameter.
DISPLAY READS X Audit ~ Trail~Setup. ~ 00003
3. Press
< to return to the Weigh Mode.
DISPLAY READS X 0.00
OMIL REQUIREMENTS
The International Organization of Legal Metrology is an inter-governmental body which harmonizes the
national metrology regulations of its worldwide members. A list of regulation publications can be obtained
from the Bureau International de Métrologie Légale (BIML) in Paris, France.
In order to configure the scale to comply with OIML requirements, P410 must be enabled in the setup
mode. Doing this will ensure the following:
• An over-load condition will result when the gross weight exceeds nine (9) graduations
over the full scale capacity.
• Full scale capacity is always referenced from the last zero calibration reference, not the
last zero acquired by pressing
<.
• Presettable parameters will give indication that a value has been entered manually.
Most NTEP requirements will also apply. See the NTEP section of this chapter for additional
considerations.
Enabling OIML Operation
See the Model 672 Technical Reference Manual for details on enabling the OIML parameters.
OTHER REQUIREMENTS
Several parameters must be considered on an individual basis as their configuration may vary with different
applications. These parameters include, but are not limited to:
Parameter Description Comment
P110 Full Scale Capacity Verify proper scale capacity.
P111 Division Size Verify that the maximum allowable number of scale divisions are not exceeded.
P112 Zero Track Verify required selection.
P114 Stability Verify required selection.
P118 Zero Range Verify required selection.
P212 Print Stability Verify required selection.
To Next Page
Loading...
