Chapter 5: Getting Started
The burner will light after the purge delay and the light in the heater switch will blink during the purge
and ignition period. Once a flame is sensed, the light will stop flashing and remain on.
3. Set the high-fire and low-fire gas pressures (See Adjusting the gas pressure):
• LP Settings: high-fire set to 6–15 lbs., low-fire set to 2–6 lbs.
• NG Settings: high-fire set to 6–10 lbs., set to 1–3 lbs.
NOTE: Do not set the pressure to low as to cause the burner to make popping noises when in
low fire. This can damage the burner.
56 Pneg–4900 TopDry Terminal™
To Next Page
Loading...