11
CUTTER INSTALLATION
The cutter on the KBM-18 is not supplied or installed on the machine unless specified. To install,
first loosen and remove the cutter nut and washer with a 27mm wrench (not supplied). Then
remove and discard the card board and foam spacer that are used to retain the cutter shaft collar
during shipping. Install the cutter onto the shaft, do not apply excess force if the cutter does not
slide on to the shaft easily, there may be burrs or damage on the cutter if it’s been excessively
used.
Reinstall the cutter nut & washer, complete the assembly by firmly tightening the cutter nut.
Cutter nut (27mm) and
washer.
Cardboard and foam spacer,
remove and discard.
To Next Page
Loading...