GULLCO KBM-18 - Operation; Bevel Settings

12
4
5
6
1
2
3
OPERATION
BEVEL SETTINGS
1. Positively isolate/disconnect the
AC power supply.
2. Clean the area around the Main
Roller and Slide Base Assembly,
then loosen the Slide Base
Clamping Bolt.
3. Lower the Slide Base Assembly
by turning the Slide Base
Adjusting Bolt counter-clockwise.
4. Loosen the nut of the Angle
Alignment Bolt.
5. Loosen the Wing Screw.
6. Tilt the Pivot Arm Assembly
upward.
7. Unscrew and remove the Angle Pin.
8. Screw in the correct Angle Pin to match the desired bevel angle to be produced.
7
8