2017_E_TYPE-HL.doc Page 7 of 55 24-Oct-2017
1.7 Air Permits
The Guspro heat-cleaning oven is state-of-the-art technology that enables safe and
economical cleaning of automotive and industrial parts, fixtures, paint hooks and racks.
However, operation of the oven will require an air permit from the local Air Pollution Control
Authority.
The process of securing a permit to construct or install process equipment like the Guspro
oven usually requires that the purchaser fill out the applicable local forms and provide
information about the process, the equipment and the location where the equipment is to be used.
Upon request, Guspro Inc. will furnish an appropriate Air Permit support package that
can be used as an application package for submittal to the local authorities. The package
generally requires completion of the Air Quality portions of local forms. Guspro Inc. will supply
supporting technical documentation such as:
• Expected stack emissions.
• Combustion gas flow rates.
• Operating temperatures.
• Heat and mass balances.
• Residence time calculations.
The purchaser must supply the following information:
• Local application forms.
• Owner of the equipment.
• Persons responsible.
• Physical locations (including plot plans where required)
• Any other information required
The purchaser is ultimately responsible for fully completing, signing and submitting the
completed forms along with any necessary filing fees.
1.8 Local Codes
The Guspro Heat Cleaning Oven is designed to comply with most building and safety
codes. If any modifications are requested for compliance with other codes or regulations,
Guspro Inc. will review the requirements. Guspro Inc will then provide a cost estimate for
additional work required to meet these standards.
To Next Page
Loading...