2017_E_TYPE-HL.doc Page 46 of 55 24-Oct-2017
Steps for normal 750
o
F set point operation:
1) Turn both ETC-P and OTS Burling controls to full scale.
2) Set instrument at 900
o
F. Bring empty oven to 900
o
F. Allow stabilizing in 15-20
minutes.
3) Bring the ETC-P down scale until process burner shuts off. This establishes 900
o
F
ETC-P synchronized safety shutoff.
4) Reset instrument to 825
o
F and allow oven to stabilize. Bring the OTS control down
scale until pump engages. This establishes 825
o
F OTS synchronized start.
5) Reset instrument to 750
o
F. With instruments synchronized, other desired instrument
settings may be used.
7.5 Adjustments
7.5.1 For Normal Loads
Almost all loads normally encountered can be processed with full on OTS operation and
a slow heat up rate to temperature. This is advisable as this allows more time for
de-volatilization. Oven heat up times typically varies from 45 to 75 minutes. Heat up times in
ovens processing automotive products is usually shorter in duration.
8.0 - GENERAL TROUBLE-SHOOTING
Guspro Inc. or its factory representative should be contacted in regards to maintenance
and repairs. The customer can perform the greater majority of repairs. In a few isolated
instances, it may be necessary to retain the services of Guspro personnel or a local service
company.
8.1 Oven Will Not Start
a) Is the fuel supply on?
The oven manifold fuel pressure gauge should read:
7" W.C. - Natural Gas
11" W.C. - Propane
To Next Page
Loading...