2017_E_TYPE-HL.doc 24-Oct-2017
Stack High Temperature Safety Controller
West 6700+ Series
Changing Set Point Instructions
Power up the West 6700+ controller
Push and hold down scroll key and tap the up key OPTr / SLCT will display
Tap the up arrow key, SETP / SLCT will display
Tap the scroll key, Uloc will display
Tap the up key to 10
Tap the scroll key SP value (1850) will display
Tap the up or down key to desired set point, push reset.
Hold the scroll and tap up key, SETP / SLCT will display
Tap the up arrow key until OPTr / SLCT will display
Tap the scroll key and the new set point and oven temperature will display
Programming is complete
To Next Page
Loading...