ZONESCAN INSTALL User Manual page – 9
2) List: View all the loggers in the project and their respective ECL, Band, Signal Power, Reachability,
and RSSI values. To update the list view swipe down to refresh.
The middle section contains logger setup and maintenance options
1) Logger Setup: Deploy loggers and upload the data to ZSNet.
2) Logger Maintenance: Check the device state, config, and log of the logger. In-detail explanation
is in section 4.2.
3) Logger Sleep Mode: Logger is put to sleep mode to save the battery life of the logger.
The bottom section contains options to import the project, change general and account settings, and
a help section to share feedback to the user.
1) Project Management: Import the latest configuration of the project.
2) Area: Change add a new area or change to another area within the project.
3) Firmware: Update to different NBIoT logger firmware version.
4) Settings: Change general settings, display settings, and account settings.
a) General Settings: Here you will be able to change Link Serial Number, Company Name and
enable or disable the Tutorials.
b) Display Settings: Display settings can be set based on Reachability or RSSI value. Based on
these values the color of the logger is set to green, yellow, or red.
c) Account Settings: Update the server username and password.
To Next Page
Loading...
Need help?
General
