ZONESCAN INSTALL User Manual page – 11
4.1.5 Adding NBIoT Logger
Check section 4.1.2 for how to configure the NBIoT Logger and then select ‘Logger Setup’ in the
navigation drawer
Once ‘Logger Setup’ is selected it goes to the ‘Setup NB-IoT device’ screen. If the OTG cable is
connected data is read from the NB-IoT logger and you can view the serial number, firmware version,
and other details of the logger.
Make sure that the Logger serial number is in the range of ‘500 000 000’ to ‘516 777 215’. If
the logger serial number is not within this range, the logger firmware needs to be updated
to v1105 or above. If not updated, you will not be able to deploy the logger.
To Next Page
Loading...
Need help?
General
