ZONESCAN INSTALL User Manual page – 30
On ‘delete alpha’, all the associated deployments and measurements of the device will be deleted.
‘Edit alpha’ can be selected if you have to change the type of alpha or redeploy the alpha in a
different position or area. Choose ‘replace alpha’ if you have to replace an old alpha with a new alpha.
On the selection of any of these functions, changes need to be uploaded to ZSNet.
6.2 Repeater Maintenance
For Repeater maintenance go to ‘List’ and select the required repeater or long-press on the repeater
on the map. Once selected, you will find three options: Repeater Details, Repeater Radio, and
Repeater.
Repeater Details
Under ‘Repeater Details’ you have the following options:
1) Repeater Details: Under this section, you can upload the device image. Select ‘Repeater Details’
and click on the ‘+’ button to add the required image.
2) Repeater Settings: If you have performed a connection test, either during deployment or with
the Alpha’s Antenna Search function explained above, the Alpha has already selected the
antenna that provides the best connection between Alpha and repeater. With this option, you
could manually override this selection by choosing a different antenna. Use this with care, as
you may lose connection with the repeater when picking the wrong antenna. Since the repeater
cannot send the antenna change to the Alpha directly, upload the project to the Gutermann
Cloud afterwards. Then in ZONESCAN NET, go to Administration > Radio Windows and send
the current configuration again, so that the Alpha can pick up the change. There is no need to
recalculate the Radio Windows.
To Next Page
Loading...
Need help?
General
