ZONESCAN INSTALL User Manual page – 25
When you log in to ZONESCAN net, you will see all the installed devices. You can calculate the radio
window settings and then transfer the settings to the ALPHAs – only then will they start working.
6 Device Maintenance
This section is further divided into three sub-sections.
6.1 Alpha Maintenance
For Alpha maintenance go to ‘List’ and select the alpha required. Alternatively, long press on the
alpha on the map. Once selected you will find three options. They are: Alpha Details, Alpha Radio, and
Alpha.
Alpha Details
Under alpha details you have the following options:
1) Alpha Details: Under this section, you can upload the device image. Select ‘Alpha Details’ and
click on the ‘+’ button to add the required image. You can check if the Alpha’s settings are
configured correctly i.e., SMTP settings and server username and password. Under POP3
Settings you can check for the port number and under Alpha Settings if the APN and other
details of the network provider are read correctly.
2) Alpha Settings: Here you can change the APN settings and other details needed for the network
registration. Alpha time settings are set to configure the time at which the alpha will additionally
read the settings email.
3) Send Test Email Request: To request alpha to send a test email. To successfully send an email.
Under ‘Alpha settings’ APN and other details needed should be correctly entered. Check with
the network provider for these details. To verify that the email was sent successfully, select the
‘Check Test Email’ option or go to ‘List’ and swipe down to refresh. If the email is received a
message is shown ‘Test email received on.’.
To Next Page
Loading...
Need help?
General
