REMOTE CONTROL
103
calc:math:perc Sets target value in Math measurement.
Parameter: NR2
Example: calc:math:perc_50 (target set to 50)
calc:hold:ref Set percentage of Hold function.
Parameter: 0 to 99, min, max
calc:hold:ref? Return percentage of Hold function.
Parameter: 0 to 99
TRIGger command
read? Returns 1
st
and 2
nd
display value.
val1? Returns 1
st
display value.
val2? Returns 2
nd
display value.
trig:sour Selects trigger source.
Parameter: int (internal), ext (external)
Example: trig:sour_ext (External trigger selected)
trig:sour? Returns current trigger source.
Parameter: INT (internal), EXT (external)
trig:del Sets trigger delay in milli-seconds.
Parameter: 0 ~ 9999, min, max
Example: trig:del_50 (trigger delay set at 50ms)
Example: trig:del_min (trigger delay set at minimum 1ms)
trig:del? Returns trigger delay in milli-seconds.
Parameter: 0 ~ 9999, min, max
trig:auto Turns trigger auto mode On or Off.
Parameter: 1 (on), 0 (off)
Example: trig:auto_1 (trigger auto mode On)
trig:auto? Returns current trigger auto mode.
Parameter: 1 (on), 0 (off)
samp:coun Sets number of sampling.
Parameter: NR1 (1 to 127)
Example: samp:coun_10 (sampling set at 10)
samp:coun? Returns number of sampling.
Parameter: NR1 (1 to 127)
trig:coun Sets number of trigger counting.
Parameter: NR1 (1 to 127)
Example: trig:coun_100 (trigger count set at 100)
trig:coun? Returns number of trigger count.
Parameter: NR1 (1 to 127)
trac:data? Returns buffer contents.
To Next Page
Loading...
