GW Instek GDM-8200A Series - Select Thermocouple Type

GDM-8200A Series User Manual
38
Select thermocouple type
Background
The GDM-8200A series assumes that a certain type of
thermocouple, which reads voltage fluctuation induced
by temperature changes, is used to measure the
temperature.
Parameter Type Range Resolution
K
0 ~ +300°C 0.01°C
T
0 ~ +300°C 0.01°C
J
0 ~ +300°C 0.01°C
1. Open sensor
selection menu
Press the Shift key, then the °C/°F
(Sensor) key. The sensor selection
menu appears on the display.
2. Select sensor
type
Press the Right key to highlight the
thermocouple type. Press the
Up/Down key. The thermocouple
type switches to the next one.
 
3. Confirm and
go back to the
default display
Press the Enter key to confirm.
Press the Exit key to go back to the
default display.