GW Instek GDM-8200A Series - Page 107

REMOTE CONTROL
107
conf2:freq Configure 2
nd
display to Frequency.
conf2:per Configure 2
nd
display to Period.
conf2:temp Configure 2
nd
display to Temperature.
conf2:off Turn off the dual display mode (2
nd
display is off)
conf2:stat:func? Returns function of 2
nd
display.
Parameter: 1 (DCV), 2 (ACV), 3 (DCA-10A), 4 (ACA-10A), 5
(DCA-mA), 6 (ACA-mA), 7 (2WR), 8 (Freq), 9 (TempC), 10
(AC+DCA-10A), 11 (AC+DCV), 12 (AC+DCA-mA), 13 (Diode),
14 (Period), 15 (TempF), 16 (4WR), 17 (Cont.)
conf2:stat:rang? Returns range of 2
nd
display. Parameter:
DCV: 1 (100mV), 2 (1V), 3(10V), 4 (100V), 5 (1000V)
ACV: 1 (100mV), 2 (1V), 3(10V), 4(100V), 5(750V)
AC+DCV: 1 (100mV), 2 (1V), 3(10V), 4 (100V), 5 (1000V)
DCA, ACA, AC+DCA: 1(10mA), 2(100mA), 3(1A)
2WR, 4WR: 1(100Ω), 2(1kΩ), 3(10kΩ), 4(100kΩ), 5(1MΩ),
6(10MΩ), 7(100MΩ)
DCA, ACA, AC+DCA (10A range): 1 (one range)
Freq, TempC, TempF, Diode, Period, Cont.: 1 (one range)
conf2:auto Set 2
nd
display to Auto range.
Parameter: 0 (disable auto range), 1 (enable auto range)
conf2:auto? Return 2
nd
display Auto range status.
Parameter: 0 (disable auto range), 1 (enable auto range)