ADVANCED MEASUREMENT
53
2. Change the parameter using the
Up/Down key.
3. Press the ENTER key to
confirm editing and move to
offset setting.
3. Set the offset
(B)
1st display
Shows the offset (B)
2nd display
Indicates MX+B (The letter B flashes)
1. Use the Left/Right key to move
the cursor (flashing point)
between the offset, digits, and
decimal point.
2. Change the parameter using the
Up/Down key.
3. Press the ENTER key to
confirm the editing. The MX+B
measurement result appears.
4. View MX+B
1st display
Shows the calculated result
2nd display
Indicates MX+B
MATH
Indicates Math operation
To Next Page
Loading...
