GW Instek GDM-8200A Series - Page 81

SCANNER (OPTIONAL)
81
6. Move the cursor to the channel
using the Left/Right key, and
change the value using the
Up/Down key.
Range
101 ~ 118, 201 ~ 218 (must be the same
or bigger than the Start (Min) channel)
7. When finished, press the
ENTER key. The Timer setting
appears.
8. Move the cursor to the channel
using the Left/Right key, and
change the value using the
Up/Down key.
Range
1ms ~ 9999ms
9. Press the ENTER key. The loop
(step) Count setting appears.
10. Move the cursor to the channel
using the Left/Right key, and
change the value using the
Up/Down key.
Range
1 ~ 999
11. Press the ENTER key followed
by the EXIT key. The setting is
stored and the display goes back
to the normal mode.