GW Instek PSW 30-108 - Cls; Ese; Esr

PSW Series Programming Manual
90
IEEE 488.2 Common Commands
*CLS ........................................................................................ 90
*ESE ........................................................................................ 90
*ESR ........................................................................................ 90
*IDN ....................................................................................... 91
*OPC ....................................................................................... 91
*RST ........................................................................................ 91
*SRE ........................................................................................ 92
*STB ........................................................................................ 92
*TRG ....................................................................................... 92
*TST ........................................................................................ 92
*WAI ....................................................................................... 93
*CLS
Set
Description
The *CLS command clears the Standard Event
Status, Operation Status and Questionable Status
registers. The corresponding Enable registers in
each of the above registers are not cleared.
If a <NL> newline code immediately precedes a
*CLS command, the Error Que and the MAV bit in
the Status Byte Register is also cleared.
Syntax
*CLS
*ESE
Set
Query
Description
Sets or queries the Standard Event Status Enable
register.
Syntax
Query Syntax
*ESE <NR1>
*ESE?
Parameter
<NR1>
0~255
Return parameter
<NR1>
Returns the bit sum of the Standard Event
Status Enable register.
*ESR
Query