GW Instek PSW 80-27 - Commands Measure[:Scalar]:Voltage[:DC]; Measure[:Scalar]:Power[:DC]; Output Commands; Output:delay:on

PSW Series User Manual
36
MEASure[:SCALar]:VOLTage[:DC]
Query
Description
Takes a measurement and returns the average
output voltage.
Syntax MEASure[:SCALar]:VOLTage[:DC]?
Return <NRf>
Returns the voltage in volts.
MEASure[:SCALar]:POWer[:DC]
Query
Description
Takes a measurement and returns the average
output power.
Syntax MEASure[:SCALar]:POWer[:DC]?
Return <NRf>
Returns the power measured in watts.
Output Commands
OUTPut:DELay:ON ............................................................36
OUTPut:DELay:OFF ........................................................... 37
OUTPut:MODE ................................................................... 37
OUTPut[:STATe][:IMMediate] ........................................... 37
OUTPut[:STATe]:TRIGgered ............................................. 38
OUTPut:PROTection:CLEar .............................................. 38
OUTPut:PROTection:TRIPped .......................................... 38
OUTPut:DELay:ON
Set
Query
Description
Sets the Delay Time in seconds for turning the
output on. The delay is set to 0.000 by default.
Syntax
Query Syntax
OUTPut:DELay:ON <NRf>
OUTPut:DELay:ON?
Parameter <NRf>
0.00~99.99 seconds, where 0=no delay.
Return parameter <NRf>
Returns the delay on time in seconds until the
output is turned on.