GW Instek PSW 80-27 - Trigger Trigger:transient[:Immediate]; [Source:]Voltage:slew:falling

PSW Series User Manual
48
Syntax
Query Syntax
[SOURce:]VOLTage:SLEW:RISing {<NRf>|MIN|MAX}
[SOURce:]VOLTage:SLEW:RISing? {MIN|MAX}
Parameter/Return
<NRf>
0.01V/s--200% (PSW 30-XX)
0.1V/s--200% (PSW 80-XX)
MIN
Minimum rising voltage slew rate.
MAX
Maximum rising voltage slew rate.
Example SOUR:VOLT:SLEW:RIS MAX
Sets the rising voltage slew rate to its maximum.
[SOURce:]VOLTage:SLEW:FALLing
Set
Query
Description
Sets or queries the falling voltage slew rate. This is
only applicable for CV slew rate priority mode.
Syntax [SOURce:]VOLTage:SLEW:FALLing {<NRf>|MIN|MAX}
Query Syntax [SOURce:]VOLTage:SLEW:FALLing? {MIN|MAX}
Parameter/Return
<NRf>
0.01V/s--200% (PSW 30-XX)
0.1V/s--200% (PSW 80-XX)
MIN
Minimum voltage falling slew rate.
MAX
Maximum voltage falling slew rate.
Example SOUR:VOLT:SLEW:FALL MIN
Sets the falling voltage slew rate to its minimum.
Trigger Commands
The trigger commands generate and configure software triggers.
T
RIGger:TRANsient[:IMMediate]......................................48
TRIGger:TRANsient:SOURce ............................................ 49
TRIGger:OUTPut[:IMMediate] .......................................... 49
TRIGger:OUTPut:SOURce ................................................. 49
TRIGger:TRANsient[:IMMediate]
Set
Query
Description
Generates a software trigger for the transient
trigger system.