H3C SecPath F1020 User Manual

19
Figure2-18 Installing an interface module
Installing a drive
CAUTION:
•
Do not hot swap drives.
•
To avoid damage to drives, always hold a drive by its sides. Do not touch any components
and do
not squeeze, vibrate, or strike a drive.
•
Install a filler panel in empty drive slots to prevent dust and ESD damage.
•
Before using a drive, execute the fdisk and format commands from the CLI to partition and
format the drive.
The device does not come with any drives and cannot recognize drives from other vendors.
Purchase drives from H3C as needed.
To install a drive:
1. Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2. Remove the filler panel from the drive slot.
3. Press the button on the drive panel to release the locking lever.
4. Hold the locking lever and push the drive into the slot slowly along the guide rails. Then close
the locking lever.
Figure2-19 Installing a drive
Connecting Ethernet cables
Connecting a copper Ethernet port
You can use either a straight-through or a cross-over network cable. For more information about
Ethernet twisted pair cables, see "Ethernet twisted pair cable."
1
2
2
3
3
2
1 3
4

H3C SecPath F1020 Specifications

General

Brand	H3C
Model	SecPath F1020
Category	Firewall
Language	English