H3C SecPath F1020 User Manual

3-26
3 Accessing the firewall
Starting the firewall
Check before starting the firewall
WARNING
!
Locate the emergency power
-off switch in the room before powering on the firewall so you can
quickly shut power off when an electrical accident occurs.
Before powering on the firewall, verify that the following conditions are met:
•
The power cord and grounding cable are correctly connected.
•
The power source specifications meet the firewall requirements.
•
The firewall is connected correctly to a configuration terminal (a PC for example). The
configuration terminal has been started and the parameters have been set correctly. For more
information, see "Logging in from the serial console port or micro USB console port."
•
The interface modules (if any) are installed correctly.
Starting the firewall and observing the initial startup
conditions
1. Turn on the circuit breakers to power on the firewall.
2. Observe the initial startup conditions to verify that the firewall starts up correctly.
 The LEDs on the front panel indicate that the device is operating correctly. For more
information about LEDs, see "Appendix B LEDs."
 The fan blades are rotating and air is exhausted from the air outlet vents.
 The configuration terminal displays the following information:
System is starting...
Press Ctrl+D to access BASIC-BOOTWARE MENU...
Press Ctrl+T to start heavy memory test
Booting Normal Extended BootWare
The Extended BootWare is self-decompressing......Done.
****************************************************************************
* *
* H3C F1080 BootWare, Version 1.04 *
* *
****************************************************************************
Compiled Date : Sep 10 2014
CPU Type : xxx
CPU Clock Speed : 1000MHz
Memory Type : DDR3 SDRAM
Memory Size : 4096MB
Memory Speed : 1332MHz

H3C SecPath F1020 Specifications

General

Brand	H3C
Model	SecPath F1020
Category	Firewall
Language	English