11
Controller configuration tasks at a glance
To configure the storage controller settings in legacy mode, perform the following tasks:
Accessing the controller configuration screen
(Optional.) Viewing drive properties
(Optional.) Locating drives
(Optional.) Verifying/Formatting drives
(Optional.) Setting advanced controller properties
(Optional.) Configuring boot options
Accessing the controller configuration screen
1. During server POST, press Ctrl+C on the screen as shown in Figure 18 to open the controller
configuration screen.
Figure 18 Legacy BIOS setup screen
2. On the screen as shown in Figure 19, press Enter.
Figure 19 Main screen
To Next Page
Loading...
