Figure 3 Product components
1 FL1500 flow logger 3 AC power cable with country-specific connector
2 Communications cable, USB A to B
Installation
D A N G E R
Multiple hazards. Only qualified personnel must conduct the tasks described in this section of the
document.
Installation guidelines
• Do not install the instrument in a location that receives direct exposure to sunlight, ultraviolet
radiation (UV), severe weather or next to a heat source.
• Make sure that there is sufficient clearance around the instrument to make connections.
• Install the instrument in an environmental enclosure or protective cover when installed outdoors.
Mechanical installation
Mounting
This instrument is rated for an altitude of 2000 m (6562 ft) maximum. Although the use of this
equipment above the 2000 m altitude does not show any substantial safety concern, the
manufacturer recommends that users with concerns contact technical support.
Attach the instrument to a wall, a rail or a pipe
1
with a diameter of 20 to 50 mm (0.75 to 2.0 inch).
Refer to Figure 4 and Figure 5. Make sure that the wall mounting is able to hold 4 times the weight of
the equipment.
8
English
To Next Page
Loading...
