4. Reposition the receiving antenna for the device receiving the interference.
5. Try combinations of the above.
Chemical and biological safety
D A N G E R
Chemical or biological hazards. If this instrument is used to monitor a treatment process and/or
chemical feed system for which there are regulatory limits and monitoring requirements related to
public health, public safety, food or beverage manufacture or processing, it is the responsibility of the
user of this instrument to know and abide by any applicable regulation and to have sufficient and
appropriate mechanisms in place for compliance with applicable regulations in the event of malfunction
of the instrument.
Product overview
The flow logger collects and analyzes water quality data from water quality sensors. The user can
install the flow logger indoors or outdoors with protection from environmental conditions. There are
two available models, a basic and advanced model. Refer to Specifications on page 3 for the
available sensor options.
The user can configure the measurement parameters from the logger or from a connected computer.
The user can also save a configured program to a USB memory stick and upload the program to the
logger (Figure 1). Refer to Figure 2 for a typical system configuration.
Figure 1 Product overview
1 Keypad 7 Mounting bracket (2x)
2 Indicator light 8 Cable strain relief—power
3 Display 9 Cable strain relief—relays (2x)
4 USB type B port for computer only 10 Cable strain relief—inputs or outputs (4x)
5 USB type A port for USB memory stick only 11 Air inlet
6 Hole, 6-mm (¼-inch), for user-supplied lock
6 English
To Next Page
Loading...
