Hach Micro Dist User Manual

25
General Procedure
5. Immediately push the D end of a collector tube over the open
end of each sample tube to start the seal (Figure 5).
6. Place the assembly in the press (Figure 5), putting the sample
tube through the hole in the white base. Before pressing, the
user should grip the collector tube firmly at the breakaway point
to keep the tube from shifting during the pressing procedure.
Figure 4 Adding the Releasing Solution
Figure 5 Starting the Seal

Hach Micro Dist Specifications

General

Brand	Hach
Model	Micro Dist
Category	Measuring Instruments
Language	English