Table 10 Calibration (continued)
Error/Warning Description Possible solution
No titrant to calibrate
There is no method to calibrate the titrant
into the application. If more than one
application is installed, there is no method to
calibrate the titrant into all the applications.
The titrant cannot be calibrated with the current
application. Refer to the related application note
to find if the titrant calibration is available.
The titrant calibration has been deactivated
(Basic or Expert mode: Active = No)
Activate the titrant calibration (Active = Yes)
Table 11 USB storage device
Error/Warning Description Possible solution
Exporting {application name} -
access forbidden to the
applications folder on USB
flash drive
Error when exporting data to the
USB storage device
Make sure that the USB storage device is correctly
installed and the USB icon can be seen in the header
bar (refer to Table 4 on page 26)
Remove the USB storage device and make sure the
USB icon is no longer seen in the header bar, then
install the device again and make sure that the icon can
be seen (refer to Table 4 on page 26)
Exporting {application name} -
read only access to the
applications folder on USB
flash drive
The USB storage device is read
only
Unlock the storage device or use another one
Exporting {application name} -
error during writing. Verify
USB flash drive is not full
Error when exporting data to the
USB storage device
Make sure that the USB storage device has enough
available space or use another one
USB flash drive is not
installed. Install and export
applications again
The instrument cannot find a USB
storage device
Make sure that the USB storage device is correctly
installed and the USB icon can be seen in the header
bar (refer to Table 4 on page 26)
Remove the USB storage device and make sure the
USB icon is no longer seen in the header bar, then
install the device again and make sure that the icon can
be seen (refer to Table 4 on page 26)
Application {application name}:
maximum number of
applications is reached
The maximum number of
applications for each line has
been reached when copying
applications to the instrument
from the USB storage device
Remove any unwanted applications, then push the
Home key to return to the home screen. Remove the
USB storage device and make sure the USB icon is no
longer seen in the header bar, then install the device
again and import the new application again
Troubleshooting
52
To Next Page
Loading...
