Section 13 Configure the instrument
1. From the home screen, select Settings. Refer also to Menu structure on page 26.
2. Select an option, then push Select.
Option Description
Applications Changes (refer to Change the application settings on page 38), makes
copies, exports and removes application data. Make sure that the
duplication function does not make more than five applications for each
syringe installed.
Operators Adds, changes and removes operators.
Date + Time Sets the instrument date and time.
Brightness Sets the brightness of the display.
Sounds Sets the sound options.
Language Sets the language.
Network Give a name to the instrument. This name is used to connect the
instrument to a PC. If a printer is connected, this name is printed on the
hard-copy output. Restart the instrument if the name is changed.
Legacy settings Specify the sensor data when the legacy adapter is used.
Info Shows information about the instrument and the attached hardware.
Restore
Defaults
Sets the instrument to the default configuration. The restored settings are:
• The language is set to English
• All password security is removed
• The security password is set to 0000
• No sound on: Key press, Information and Analysis results OK
• Sound on: Instrument ready, Instrument switch off, Errors and
Analysis results not OK
• The application parameters view is set to basic mode
• Sets the syringe to empty when the instrument is set to off
• The temperature display unit is set to °C
• No print of the measurement curve
• No print of the derivative curves
• No balance is connected
• No propeller stirrer is connected
• The default stirring is set to 10%
• The user is set to "Default user"
75
To Next Page
Loading...
Need help?
General
