What to do if Haefely Technology AXOS5 Test Equipment shows EUT requires more than 16 A?
If your EUT requires more than 16A support current, it might be defective or have a short circuit. First, check the Inominal of the EUT, noting that the AXOS5 supports a maximum of 16A. Control the EUT independently to check for a short circuit. If a higher Inominal is required, an external CDN is necessary.
Why does my Haefely Technology AXOS5 Test Equipment beep once and automatically shut down?
If the AXOS5 Test Equipment produces one beep and automatically shuts down, it could be due to several reasons. It could be that at system startup any of the internal supply voltages (excluding 24V) are out of range, or the internal supply voltage 24V is out of range. Another cause might be a bad or missing Function Key or a missing or damaged internal storage card. In the first two cases send AXOS5 for repair. In the third case, go to Setup License Manager and check for correct numbers or send for repair.
What to do if I tried to start a Test with open Safety Circuit on Haefely Technology AXOS5?
If you tried to start a test with an open safety circuit on your Haefely Technology Test Equipment, close the safety circuit and start the test again.
What to do if Frequency of EUT Supply Input is too high on Haefely Technology AXOS5 Test Equipment?
If the frequency of the EUT Supply Input is too high on your Haefely Technology Test Equipment, use an EUT Supply Input voltage with a nominal frequency of 50 or 60 Hz.
Crucial safety precautions and warnings for operating the AXOS.
Instructions for inspecting the unit for damage before operation.
Common error messages and their possible causes and actions.
Procedures and equipment for verifying the AXOS performance.
General| Brand | Haefely Technology |
|---|---|
| Model | AXOS5 |
| Category | Test Equipment |
| Language | English |
To Next Page