GB
Modus 600RT 17
Attaching to Camera
1. Attach the Speedlight
to the camera.
Slip the ash’s
mounting foot into the
camera’s hotshoe all
the way.
2. Secure the Speedlight
Rotate the lock ring on
the mounting foot until it
locks in position
3. Detach the Speedlight
Rotate the lock ring on
the mounting foot until it
is loosened. Then slide
the speedlight off the
camera hotshoe
Power Management
Use ON/OFF Power Switch to power the ash unit on or
off. Turn off if it will not be used for an extended period of
time. Setting as a master ash, it will turn the power off
automatically after a certain period (approx. 90 seconds)
of idle use. Pressing the camera shutter halfway or
pressing any ash button will wake up the ash unit.
Setting as a slave ash, it will enter sleep mode after a
certain period (adjustable, 60 minutes by default) of idle
use. Pressing any ash button will wake it up.
Disabling Auto Power Off function is recommended
when the ash is used off camera. (C.Fn-APO)
Slave Auto Power Off Timer is set to 60 minutes by
default. Another option “30 minutes” is available. (C.Fn-
Sv APOT, Page 42)
To Next Page
Loading...
