Hahnel modus 600rt - Other Applications and Technical Data; Special Features and Custom Functions

GB
40 Modus 600RT
Other
Applications
6
Sync Triggering
• The Sync Cord Jack is a Φ2.5mm plug. Insert a trigger
plug here and the ash will be red synchronously with
the camera shutter.
• To avoid overheating and deteriorating the ash head, do
not re the modeling ash for more than 10 consecutive
times. If you re the modeling ash 10 consecutive times,
allow at least 10 minutes’ break for the camera ash.
• The modeling ash cannot be red with the EOS 300 and
Type-B cameras.
Auto Focus Assist Beam
In poorly-lit or low-contrast shooting environments, the
built-in auto focus assist beam will automatically switch on
to make it easier to autofocus. The beam will light up only
when autofocus is difcult and will switch off as soon as
the autofocus is set.
If you want to turn off the auto focus assist beam, set “AF”
to “OFF” on the C.Fn settings.
• If you nd the auto focus assist beam does not light up,
this is because the camera has got a correct autofocus.
Bounce Flash
By pointing the ash head toward a wall or ceiling, the
ash will bounce off the surface before illuminating the
subject. This can soften shadows behind the subject for a
more natural-looking shot. This is called bounce ash.
Tosetthebouncedirection,holdtheashheadand
turn it to the required angle.
360
-7-90
• If the wall or ceiling
is too far away, the
bounced ash might be
too weak and result in
underexposure.
• The wall or ceiling should
be a plain, white color for
high reectance. If the
bounce surface is not
white, a color cast may
appear in the picture.