Hakko Electronics FM-202 - Page 17

• The low-temperature
alarm tolerance error
\H-E \ o ccurs frequently.
• Tip ID error Ifc-fl is
displayed
• Heater terminal short
Circuit error \hSS\ is dis-
piayed
CHECK
CHECK
: Is the tip too small for the items to be soldered?
: Use a tip with a larger thermal capacity.
: Is the setting value for the low-temperature alarm toler¬
ance too low?
: Increase the setting value.
CHECK
: Is the procedure of the entering tip identification number
correct?
: Entering correctiy.
NOTE:
If reinsert the tip into the process gate and buzzer sounding three limes. Try
to insert again or entering the Tip ID by hånd operation.
CHECK : Is the tip for FM-2027?
: Turn the power switch OFF and insert
FM-2027 tip. Turn the power switch ON.
the genuine
NOTE:
This error does not display when not entering the Tip ID.