29
Operation
2.3.9 After completing cleaning
1. Drive to an appropriate maintenance
area.
2. Stop the vehicle, raise the brush
head and squeegee and remove the
key.
3. Empty the waste water tank and
flush it.
Observe the applicable laws
and local regulations when dis-
posing of cleaning agents.
4. Check the clean water filter
(Fig. 16/1).
5. Check the sealing strips (Fig. 16/2)
and suction hose (Fig. 16/3).
6. Check the electrical equipment,
functions and settings.
7. For information on charging the bat-
tery, refer to Section 2.3.1
8. Clean the machine. If the machine is
to be shutdown for a longer period,
the clean water tank must be emp-
tied.
It is not permitted to clean the
vehicle with a pressure washer
or steam blaster.
Fig.16
To Next Page