8
Safety Information
• When using the vehicle, it is essen-
tial to pay attention to third parties,
especially children.
• Start driving immediately after
switching on the brush head drive
otherwise imprints of the brush could
be produced on the floor. Always
raise the brush head before driving
over thresholds.
• Only use cleaning agents suitable for
the vendor (non-foaming) and ob-
serve all the use, disposal and warn-
ing information provided by the
cleaning agent manufacturer.
• Never vacuum up any explosive flu-
ids, undiluted acids or solvents! Ex-
amples of these include gasoline,
paint thinner and heating oil, which
can form explosive gases or mix-
tures when swirled up with the vacu-
umed air, and also acetone,
undiluted acids and solvents if they
corrode materials in the vehicle.
• For safety reasons, the driver's seat
is equipped with a seat contact
switch. The vehicle can only be start-
ed when the operator is sitting on the
driver's seat. The function of the seat
contact switch must not be by-
passed.
• The vehicle is not suitable for clear-
ing up hazardous, inflammable or
explosive fluids, dust or substances.
• It is forbidden to use the vehicle in
potentially explosive atmospheres.
• It is forbidden to transport persons or
heavy objects.
• It is forbidden to tow machines or op-
erate as a trailer.
• Remove the ignition key to prevent
unauthorized use of the vehicle.
• When driving the vehicle to the area
of use, the squeegee and brush
head must be raised. The style of
driving must be adapted to the local
conditions.
• The vehicle has been conceived for
use on level surfaces with a maxi-
mum gradient of 2%.
• Drive slowly on wet ground due to
the risk of skidding, particularly when
cornering. Drive especially slowly
when cornering while driving down-
hill.
• Only drive uphill on gradients up to
10% for maximally 1 minute and with
the utmost care.
1.4 Maintenance information
• Operating personnel must complete
the necessary daily and weekly
maintenance work. All other mainte-
nance work must be completed at
your nearest authorized Hako ser-
vice center.
• The maintenance work and mainte-
nance intervals prescribed in the op-
erating manual must be adhered to.
• Suitable tools must be used for
cleaning and maintenance work.
• The vehicle must be inspected by a
recognized technical expert in re-
spect of operational safety, within
the terms of the applicable accident
prevention laws, at reasonable inter-
vals (we recommend at least once a
year) and following modification or
repairs .
• Spare parts must comply with the
minimum technical requirements
stipulated by the manufacturer! This
is ensured by the use of original
spare parts.
• The vehicle and motors must be
switched off prior to cleaning or ser-
vicing it or to replacing parts.
• Remove the ignition key to prevent
unauthorized use of the vehicle.
To Next Page
Loading...
