54
Maintenance and Service
Hako system maintenance III/S
(safety check)
The following maintenance work must
be completed by an authorized Hako
service center at least once a year.
Activity
Interval
Every 1000 operating hours
All maintenance work in accordance with Hako system maintenance II o
Clean carbon dust from the drive motor and check the carbon brushes move easily
and for signs of wear; change the carbon brushes, if necessary
o
Clean carbon dust from the brush motors and check the carbon brushes move easily
and for signs of wear; change the carbon brushes, if necessary
o
Test drive and function test o
To Next Page
Loading...
