26 03-7150-00.fm
Operation
2. Unlock the tank cap:
Pull out the locking bolt Fig. 7-1, push the tank cap Fig. 7-2 upwards and
release the locking bolt Fig. 7-3.
3. Tilt the solution tank Fig. 7-4 to the rear and remove it.
4. Fill the solution tank three-quarters full (maximum water temperature
50 °C).
5. Add detergent to the tank according to the manufacturer’s specifications
(see table).
6. Fill the tank with fresh water up to the maximum mark.
7. The solution tank is inserted in the reverse order.
3.4 Cleaning
1. Fold up the stand for the park position.
2. Lower the squeegee onto the ground with the footrest.
3. Press the ON/OFF button for approx. 3 seconds.
The machine is ready for use.
Press the ON/OFF button again briefly.
The suction function is switched on.
4. Hold the operating handle with one hand and release the rotary lock with
the other.
The operating bar is unlocked and can be moved into the working position.
At the same time, the drive of the cleaning tools and the water supply will
switch on.
5. Adjust the fresh water quantity with the button on the control panel.
6. For more cleaning performance, switch off ECO mode.
7. Push the machine in the desired direction.
To Next Page
Loading...
