38 05-7150-00.fm
Maintenance and servicing
5.4.2 Cleaning the solution and waste water tank
Empty and clean the tanks daily or as required.
1. Drive to a suitable disposal point.
2. Turn off the machine and remove the tanks, see section 5.4.1.
3. Empty the tanks over a drain in the floor Fig. 12-1 and rinse them
thoroughly with fresh water Fig. 12-2.
4. Also clean the sieve insert thoroughly Fig. 12-3.
5. Reinsert the tanks after cleaning and allow them to dry with the tank cap
up and open, see section 3.6.
Attention!
After drying, place the sieve insert into the waste water tank and press it in
fully. Ensure that the installation position is correct!
Environmental danger
Observe applicable laws and local regulations when disposing of
detergents!
To Next Page
Loading...
