03-7150-00.fm 27
Operation
3.4.1 Suction only
If only water is to be sucked up with the machine, proceed as follows:
1. Fold up the stand for the park position.
2. Lower the squeegee onto the ground with the footrest.
3. Press the ON/OFF button for approx. 3 seconds.
The machine is ready for use.
Press the ON/OFF button again briefly.
The suction function is switched on.
4. Tilt the machine a little to the rear Fig. 8 and suck up the water.
3.5 Turning off the machine
1. Move the operating bar to the vertical position and lock it with the
rotary lock.
The drive of the cleaning tools and the water supply are switched off.
2. Press the ON/OFF button for approx. 3 seconds.
The suction continues to run for approx. 10 seconds to allow residual water
to be sucked up. After that, the machine is turned off.
To Next Page
Loading...
