27
11.4.2 Access favourites
Press [memory]toopen the overview window with the list
of saved stations.
[memory]
Use [enter/navigate]toselect one of your favourites.
Note
Favourites cannot be deleted.
If all 30 station memory slots arelled and you wish to
save anew station, choose one of the occupied slots.
The station in this slot will be overwritten with the new
station.
11.4.3 Management of favourites with the
remote control
The remote control enclosed has number keys 1-10.
Afavourite can be assigned to each of these number key.
• To save afavourite, press and hold the corresponding
number key on the remote control (approx. 3seconds).
• The radio conrms that the favourite has been saved by
displaying Preset stored.
• To call up afavourite, briey press the corresponding
number key on the remote control.
Favourites 1-10
The remote control enclosed has number keys 1-0
(0
≙
10). Afavourite can be assigned to each of these
number key.
• To save afavourite, press and hold the corresponding
number key on the remote control (approx. 3seconds).
• The radio conrms that the favourite has been saved by
displaying Preset stored.
• To call up afavourite, briey press the corresponding
number key on the remote control.
Favourites 1-30 (alternative to number keys)
•Press and hold [FAVORITES]approx. 3seconds to save
astation on one of the 1-30 favourite station presets.
An overview window with the station presets should
open after approx. 2seconds.
•You can switch between the station presets (1 to 30) by
pressing the favourite keys [+] /[-] (by turning [enter/
navigate]).
• Press [OK]([enter/navigate]) to save the station on
the desired station preset.
• To call up afavourite, briey press [FAVORITES], select
the desired station preset by pressing the favourite keys
[+] /[-] (by turning [enter/navigate]) and conrm the
selection by pressing [OK]([enter/navigate]).
11.5 Audio setting
Forsome stations with aweak signal, quality can be
slightly improved by playing them in mono quality.You
can enable this function in the menu, and the radio will
automatically switch to mono reception when signal
quality is poor.
To change the audio setting, proceed as follows:
[menu]
Audio
setting