GENERAL
14 © HAMM AG 2009
• During towing, keep the specified trans-
port position, the admissible speed and
the travel path.
ROPS cabin
• The machine frame must not be warped,
bent or cracked in the cabin fixing area
(deformation).
• The reinforcement elements of the ROPS
cabin must not show rust, damage, fis-
sures or open fractures.
• All screwed connections of the reinforce-
ment elements must comply with the given
specifications and must be screwed tightly
to each other (observe tightening torque
values).
• Bolts and nuts must not be damaged, bent
or deformed.
• Additional parts may not be installed to the
reinforcement elements without the manu-
facturer's approval.
• Any change to the reinforcement elements
which would decrease its strength, is inad-
missible.
ROPS anti-rollover bar
• The machine frame must not be warped,
bent or cracked in the ROPS fixing area
(deformation).
• The ROPS must not show rust, damage,
fissures or open fractures.
• All screwed connections must comply with
the given specifications and must be
screwed tightly to each other (observe
tightening torque values).
• Bolts and nuts must not be damaged, bent
or deformed.
• Additional parts may not be installed with-
out the manufacturer's approval.
• Any change which would decrease the
strength of the ROPS is inadmissible.
To Next Page
Loading...
