© HAMM AG 2009 41
OPERATION
2.2 DRIVING
2.2.1 General
What must be done prior to start of work?
• Perform control and maintenance works
(see maintenance section).
• Keep step-on surfaces and driver's stand
free from stumbling hazards, grease, dirt,
ice etc.
• Check the turning lights (303) and warning
lights (305), as well as the signal horn
(301) and the illumination (307).
• Check the parking brake (304).
•
• Never drive the machine until the fuel tank
is empty. Check the filling level of the fuel
tank in time. Fill up fuel tank in the
evening; this avoids the precipitation of
condensed water in the empty tank.
Fill up to the lower edge of the filling spout.
Only use clean fuel!
• Check the filling level of the water tank. Fill
up to the lower edge of the filling spout.
Use clean water only!
Danger of accidents by operating errors!
Prior to every start-up:
Check the machine for operational and
traffic safety!
Read and observe the operating instruc-
tions and the safety notes!
Danger of explosion and increased fire
hazard during fuel handling!
Only fill up fuel when the engine is at a
standstill. Do not smoke during the filling-
up process!
Never fill up fuel near open flames or ignit-
ing sparks. Do not fill up fuel in closed
rooms!
Notes on filling up fuel, see section “Fuel”.
To Next Page
Loading...
