© HAMM AG 2009 65
MAINTENANCE
3.6 MAINTENANCE ONCE EVERY 10 OPERATING HOURS
(see also engine operating instructions)
3.6.1 Maintenance points at the
engine for engine oil change
The running-in regulations, the maintenance
intervals and the care measures for the diesel
engine can be found in the operating instruc-
tions of the engine manufacturer and must be
observed.
• A Oil filling spout
• B Oil dipstick
• C Oil drain screw
3.6.2 Check and clean dry air filter
The operability control of the air filter cartridges
must be performed prior to start of work with
the diesel engine running.
• Shortly rev up the diesel engine to maxi-
mum speed.
If the illuminated indicator (203) does not light
up, both filter cartridges are still completely op-
erable. If the illuminated indicator flashes, both
air filter cartridges must be replaced. Observe
the engine operation instructions!
Replacement of air filter cartridges
• Open the clamps A at the air filter housing
and and remove dust collector B in upward
direction.
• Check seals, replace if necessary.
Only lubricants with this identification are
admissible, see lubricant indications 3.2.
15003-10
B
A
C
15004-10
C
AB
To Next Page
Loading...
