OPERATION
48 © HAMM AG 2009
2.2.6 Stop, switch off engine, leave
machine
Stop
• Vibration (312) ..................................OFF
• Driving lever (501).......................CENTRE
The hydrostatic drive brings the machine to a
stop.
Before switching off the engine
• Vibration (312) ..................................OFF
• Parking brake (304) ...................APPLIED
• Engine speed (504).............................MIN
• Fully lower attached accessory equipment.
Switch off engine
• Key switch (310) ...............................I → 0
Leaving the machine
The driver may only leave the machine when
orderly parked. Traffic regulations have to be
observed as well.
Before leaving the machine, the driver must
ensure that
• the parking brake is applied (304), in-
stalled add-on devices are lowered, and
that the engine is shut off.
• the key switch (310) is in latch position 0
and the ignition switch is pulled off.
• the cabin doors or the dashboard cover, as
well as all cladding covers are locked.
• the machine is secured against rolling
away with a wedge, in particular on
slopes.
• the machine does not obstruct the traffic
on public roads. If this cannot be avoided,
set up warning signs (illumination) accord-
ing to safety regulations.
Danger of accidents and danger of inju-
ries!
When leaving the driver's stand, even for
only a short time, the driver must shut
down the engine!
Carry out maintenance work only when the
engine is stopped!
15000-10
302 310
504 503
501
Do not switch off engine from full load op-
eration, instead, let it run for 1-2 minutes
with idle speed for temperature compensa-
tion purposes.
When the engine is at a standstill and the
electric system is switched on for a longer
period (key position I), the battery dis-
charges rapidly.
Danger of falling!
Do not park the machine on batters or bat-
ter edges. Do not park the machine on
loose or shortly dumped ground. On
slopes, always park the machine on the
hillside and secure it against rolling away
with a wedge.
To Next Page
Loading...
