Hamm HD 8 VV - Control of Oil Level in the Hydraulic Oil Tank; Control of Refrigerant Level for Engine Cooling System

MAINTENANCE
66 © HAMM AG 2009
• Clean the inside of the dust collectors.
• Replace air filter cartridges C.
• Install in reverse order.
3.6.3 Control of oil level in the
hydraulic oil tank
• Perform this control only when the engine
is cold.
• Unscrew purge filter A.
• Correct oil level: Between the Min. and
Max. there is a mark on the dipstick which
applies when the purge filter is screwed in
Do not exceed this oil level!
• Fill in appropriate oil if the oil level is low.
• In case of bigger oil losses, find out and
eliminate the cause.
3.6.4 Control of refrigerant level for
engine cooling system
• Only check the refrigerant level when the
engine is cold.
• Correct refrigerant level: Between the Min.
and Max. mark at the compensation tank.
• In case of a lack of refrigerant, only fill up
refrigerant with the specified concentra-
tion.
• In case of bigger refrigerant losses, find
out and eliminate the cause.
Only lubricants with this identification are
admissible, see lubricant indications 3.2.
15114-10
MAX
MIN
A
Only lubricants with this identification are
admissible, see lubricant indications 3.2.
15072-10