© HAMM AG 2009 17
GENERAL
• Remove wedges and lashing devices
completely before unloading. Unblock
steering system by unblocking the articu-
lated frame steering block.
• All safety devices removed for transport
purposes (anti-rollover device ROPS, han-
dles, silencers etc.) must be installed to
the machine prior to using it.
• Drive the roller slowly and carefully from
the loading area.
Load securing
• Position 2 wedges at each axis, as far to
the outside as possible, flushing with drum
or tyre, and fix them with 3 nails each to
the loading area.
• The lashing devices A and B must be fixed
to the lashing point of the machine and at
the vehicle. The permitted tractive force
must be at least 2000 daN also at the lash-
ing point.
The arrangement of the lashing devices shown
in the figure must be realised on both sides.
10080-10
1 m
A
1 m
B
(39.37")
(39.37")
To Next Page
Loading...
