PIANO / ENSEMBLE Voice Sections 47
From the screen shown at the bottom of the previous page, press the DIRECTION “q” button once.
The box to the right of “BREAKPOINT” should be highlighted.
BREAKPOINT LEVEL
This Parameter allows you to adjust the level of the point immediately following the Attack. You can select
from 0 to 127. A higher value will set a higher pitch as the Breakpoint.
Turn the VALUE knob to the right to increase the Breakpoint Pitch.
Turn the VALUE knob to the left to decrease the Breakpoint Pitch.
From the above screen, press the DIRECTION “q” button once.
The box to the right of “SLOPE RATE” should be highlighted.
SLOPE RATE
This Parameter allows you to adjust the time from the Breakpoint Level to the Sustain Level. You can
select from 0 to 127. A higher value decreases the time required for the pitch to return to the base
frequency. A lower value increases the time.
Turn the VALUE knob to the right to increase the Slope Rate.
Turn the VALUE knob to the left to decrease the Slope Rate.
To Next Page
Loading...
