PIANO / ENSEMBLE Voice Sections 59
From the screen shown at the bottom of the previous page, press the DIRECTION “q” button once.
The box to the right of “DECAY RATE” should be highlighted.
DECAY RATE
This Parameter allows you to adjust the time from the peak amount to the Breakpoint Level. You can
select from 0 to 127. A higher value results in a longer rate.
Turn the VALUE knob to the right to increase the Decay Rate.
Turn the VALUE knob to the left to decrease the Decay Rate.
From the above screen, press the DIRECTION “q” button once.
The box to the right of “BREAKPOINT” should be highlighted.
BREAKPOINT LEVEL
This Parameter allows you to adjust the level of the point immediately following the Attack. You can select
from 0 to 127. A higher value will set a higher pitch as the Breakpoint.
Turn the VALUE knob to the right to increase the Breakpoint Level.
Turn the VALUE knob to the left to decrease the Breakpoint Level.
To Next Page
Loading...
