H&S HSM250 - Operation Environment; Operation Notices

OPERATION
-63-
3.0
1.2
100-12
0
19-21
40-60
13-17
15-20
4.0
1.2
120-15
0
20-22
50-70
15-20
15-20
6.0
1.2
150-18
0
20-23
50-70
18-22
18-22
4.0
1.2
180-21
0
21-24
35-50
18-22
16-18
4.0
1.6
180-21
0
18-20
35-45
18-22
18-22
6.0
1.2
220-25
0
24-25
50-60
18-22
16-24
6.0
1.6
220-24
0
20-24
37-50
18-22
16-24
8.0
1.6
250-30
0
25-26
60-65
18-22
16-24
12.0
1.6
300-40
0
26-28
65-75
18-22
16-24
§4.6 Operation Environment
▲ Height above sea level ≤1000 M
▲ Operation temperature range 14 - 104°F (-10～+40°C)
▲ Air relative humidity is below 90%
▲ Preferable site the machine some angles above the floor level does not exceed 15°.
▲ Protect the machine against high moisture, water AND against direct sunshine.
▲ Take care that there is sufficient ventilation during welding. There must be at least
1-1/2” (38cm) free distance between the machine and wall.
§4.7 Operation Notices
▲ Read Section §1 carefully before starting to use this equipment.
▲ Ensure that the input is 208-240VAC, single-phase: 50/60Hz.
▲ Before operation, clear the working area. Do not watch the arc in unprotected eyes.
▲ Ensure good ventilation of the machine to improve duty cycle and life.
▲ Turn off power supply when the operation finished for energy consumption efficiency.
▲ When power switch shuts off protectively because of failure. Don’t restart it until
problem has been resolved. Otherwise, permanent damage could occur.
▲ In case of problems, contact your local dealer.