Hangar 9 B25J Mitchell ARF - Page 32

31
  Step 3
Use a short 8-32 socket head bolt and 9-64-inch
ball driver to draw the 8-32 blind nuts into the back side
of the firewall.
  Step 4
Use a drill and 5/32-inch (4mm) drill bit to enlarge the
hole for the throttle pushrod.
  Step 5
Use medium CA to glue the pushrod housing into the
firewall.
  Step 6
Use side cutters to cut the pushrod tube 1/4-inch (4mm)
behind the forward edge of the opening for the throttle
servo.
Section 6: Glow Engine Installation