Hangar 9 B25J Mitchell ARF - Page 35

34
  Step 16
Apply a few drops of thin CA into each hole to harden the
surrounding wood. You may need to run the drill bit back
through the holes after applying the CA.
  Step 17
Mount the servo in the engine nacelle as shown.
  Step 18
Electronically move the throttle servo to low, and
physically close the carburetor. Secure the position of
the wire using a 2mm setscrew and the included 1.5mm
hex wrench.
Note: Use threadlock on the setscrew
to prevent it from vibrating loose.
  Step 19
Use side cutters to trim the pushrod wire so only 1/2-inch
(12mm) extends beyond the rear of the pushrod connector.
Section 6: Glow Engine Installation